Description The DS26C31 device is a quad differential line driver
• TTL Input Compatible designed for digital data transmission over
balanced
• Typical Propagation Delays: 6 ns lines. The DS26C31T meets all
the requirements of
• Typical Output Skew: 0.5 ns EIA standard RS-422 while retaining
the low power
• Outputs Will Not Load Line When V characteristics of CMOS. The
DS26C31M is CC = 0 V compatible with EIA standard RS-422; however,
one
• DS26C31T Meets the Requirements of EIA exception in test
methodology is taken(2) . This Standard RS-422 enables the
construction of serial and terminal
• Operation From Single 5-V Supply interfaces while maintaining
minimal power
• Tri-State Outputs for Connection to System Buses consumption.
• Low Quiescent Current The DS26C31 accepts TTL or CMOS input
levels and
• Available translates these to RS-422 output levels. This part in
Surface Mount uses special output circuitry that enables the
drivers
• Mil-Std-883C Compliant to power down without loading down the
bus. This device has enable and disable circuitry common to all 2
Applications four drivers. The DS26C31 is pin compatible to the
Differential Line Driver for RS-422 Applications AM26LS31 and the
DS26LS31. All inputs are protected against damage due to
electrostatic discharge by diodes to VCC and ground.
Manufacturer: Texas Instruments
Product Category: RS-422 Interface IC
Installation style: SMD/SMT
Package / Case: SOIC-Narrow-16
Series: DS26C31T
Function: Driver
Number of Exciters: 4 Driver
Number of receivers: 0 Receiver
Supply Voltage - Maximum: 5.5 V
Supply Voltage - Min: 4.5 V
Operating supply current: 2 mA
Minimum operating temperature: - 40 C
Maximum operating temperature: + 85 C
Package: Reel
Package: Cut Tape
Package: MouseReel
Trademark: Texas Instruments
Operating supply voltage: 5 V
Output current: 150 mA
Output voltage: 1.8 V
Pd-Power Dissipation: 1226 mW
Product: RS-422 Drivers
Product Type: RS-422 Interface IC
Propagation Delay Time: 11 ns
Shutdown: No Shutdown
Factory Packing Quantity: 2500
Subcategory: Interface ICs
Unit weight: 155.100 mg
